Teac X-10 X-7R spigot plastic only however there is a diecast

however there is a diecast section here which could break plus the pinch wheel shaft so maybe worth listing

The original plastic ones are actually not made very well and a few thou out though it does not pull them too far away on the wow and flutter specs

There is no part number on these just a lot number an I do not have the manual yet

I have had the motor running and not noticed any problems

I had never seen that

Teac X-10 X-7R spigot plastic only however there is a diecastOk this part needs a bit of explaining (just so I will remember), This was from either an X 7R or an X 10R I do not remember but there are two of these on a pcb on a bracket with a solenoid on and a bar runs between the solenoid. I have seen a photo of something similar on the X 1000 but there is was reversed if that makes sense I am guessing its the same part but I would need to check the service manual to be sure. These spigots get broken often so