Ferrograph capstan roller for the S7 range, the Seven, Super Seven and the Logic. I have notice in an

I have notice in an earlier ghost they link across a conection from the blue wire on the right to the earth tag on back of the fader later ones do not have that  all are marked 10k(ohm)d then 3 letters that seem to vary even in same mixer and I presume are lot codes unless someone tells me different

Very clean from a low use machine

This is the standard bush seen on many of the Teac Tascam reels but it has a silver spacer

this is from a working unit

Removed from a clean and well looked after unit there are two channels on a board

Ferrograph capstan roller for the S7 range, the Seven, Super Seven and the Logic. I have notice in anI was asked many times to produce these and I found that I had a tyre that was close enough but I had to make a new hub as it was not quite correct. Normally if someone specifies a drawing to a CNC shop of 6. 35 mm ( 1 4inch) if its the shaft engineers make a bit under if its a hole they make a bit over But ! in the Logic series the shaft is over 6. 35 so these have been made a little bit bigger as a standard hub would not fit. Fresh rubber, lovely.